Temperature Control Unit | Oil Unit | 12kW 2HP | Heating Only

Temperature Control Unit | Oil Unit | 12kW 1HP

RK-1250H

Click Here for An Immediate Factory Pricing Quote For the RK-1250H ▶

Pricing Is Now On Display

Product Overview

The Regal Series hot oil temperature control units are designed to control the temperature of your process by circulating a high temperature heat transfer fluid through the process.
The Regal Series can be used in a wide range of industrial processes including; plastics, rubber, die casting as well as many other manufacturing processes that require a process fluid temperature range between 100˚F - 500 F.
A high flow pump circulates the fluid at the appropriate temperature to maintain a precise fluid and process temperature.
Depending on whether the process needs to be heated or cooled the circulated fluid is either heated by the electric heater or cooled indirectly via the available water to oil heat exchanger.
These units are designed with the highest quality components and can be customized to meet your specific requirements.

Price is Loading

Specifications

Specification Notes:

Since product innovation and improvement is our constant goal, all features and specifications are subject to change without notice or liability. Selection of certain optional features may change listed specifications.
Derate heater output by 25% for 208/3/60 operation.
Maximum Total System @ 15% expansion = unit volume plus piping and prodcess volumes. Typical fluid expansion rates: a. Paratherm OR : 4.00% per 100°F b. Paratherm NF : 3.04% per 100°F c. Multitherm PG-1 : 3.10% per 100°F d. Calflo FG : 5.62 per 100°F
Do not use Multitherm 603.
Full load amps are higher than run load amps and must be used for sizing disconnects and supply wiring. Not for construction. Consult factory for power requirements of unit as configured and on selected options.
Consult factory for 50HZ operation.
Unit weight crated for shipment. Weight shown for APT-RC unit only. Weight for remote air-cooled condenser shown separately.
See Product Warranty Statement W-700 for details on warranty.

Features

Process Pump
2 HP provides 50 GPM at 28 PSI
Low pressure, high flow centrifugal pump eliminates high pressure safety concerns
Custom designed pump casings produce higher flow with less horsepower
Water cooled pump seal maintains seal integrity and lengthens service life
Seal cooling is provided by facility water circulated within a cast jacket surrounding the seal area
Process Connections
Female NPT fittings standard on all process connections
To and From Process connections supplied with shut off valves
Supplied with manual process fluid purge system allowing purging of the process for storage within the unit expansion tank. Requires low pressure compressed air source for operation.
Cabinetry & Frame
Stainless steel enclosure panels
Hinged electrical panel
Portable, on casters