Air-Cooled Water Chiller

• Portable chillers use mechanical refrigeration to cool recirculated fluids that support industrial process cooling applications.
• Portable chillers include an internal pumping system and reservoir system.
• Portable chillers can be moved between use points as needed.
• Air-Cooled chillers use indoor ambient air to dissipate the heat from the refrigeration system.

M1-3A
• Unit Cooling Capacity
• (2) Tons : 2.9
• kW : 10.8
• Compressor
• HP : 3
• Type : Hermetic
• Process Pump
• HP : 3/4
• GPM : 7.2
• PSI : 30
• Type : Centrifugal
• Construction : Stainless Steel
• Air-Cooled Condenser
• Type : Fan
• Fan Quantity :
• Fan Horsepower : (for each motor)
• CFM : 3,000
• (3) Ambient : 95°F
• Refrigerant
• Type : R-410A
• Full Load Amperage
• 230/3/60 : 20
• 460/3/60 : 10
• Reservoir Capacity
• Holding : 7.5 gal
• Lid : Optional
• Auto Make-Up : Optional
• Dimensions
• Height : 43"
• Width : 34"
• Depth : 40"
• Process Connections
• To Process : 1"
• From Process : 1"
• Weight
• Shipping : 600 lbs

• Specification Notes:
• 1. Since product innovation and improvement is our constant goal, all features and specifications are subject to change without notice or liability. Selection of certain optional features may change listed specifications.
• 2. Tons capacity at 12,000 BTU/ton per hour @ 50°F LWT @ " 115°F condensing temperature. Capacities may be +/- 5% as reserved by the compressor manufacturer. Operating at temperatures below 50° will reduce chiller capacity. The minimum recommended operating temperature when no glycol is used is 48°F.
• 3. Design ambient conditions. Loss of capacity and/or difficulty operating will occur at higher ambients. Minimum recommended ambient is 60°F.
• 4. Full load amps are higher than run load amps and must be used for sizing disconnects and supply wiring.
• 5. Approximate unit weight crated for shipment.

• Manual
• 
• Download
• 66 pages
• 5.4 MB

• Literature
• 
• Download
• 8 pages
• 7.01 MB

M1-3A

Image is typical. Actual unit appearance will vary according to specifications and options.