Central Water Chiller : Water-Cooled

To See an Immediate Price Quote

Click Here

• Advantage Titan water-cooled central chillers use mechanical refrigeration to cool recirculated fluid that support industrial process cooling applications.
• 20°F to 70°F process fluid temperature range.
• Titan systems combine one or more refrigeration circuits with a large capacity reservoir and pumping system assembled on a single skid for low ease of installation.
• Water-cooled chillers require a secondary water source (typically cooling tower water) to dissipate the heat from the refrigeration system.

TI-90W
• Refrigerant Zones
• Quantity : 3
• Compressor
• Quantity : 3
• HP : 30
• Type : Scroll
• (2) Total Capacity : 90 Tons
• Refrigerant
• Type : R410A
• Water-Cooled Condenser
• (3) City Water : 128 GPM
• (4) Tower Water : 255 GPM
• Process Pump (5)
• HP : 15
• GPM : 270
• PSI : 65
• Evaporator Pump (5)
• HP : 5
• GPM : 205
• Reservoir Capacity
• Operating : 1200 gal
• Holding : 1475 gal
• Connection Sizes
• To Process : 4"
• From Process : 4"
• Water Make-Up : 1-1/2"
• Overflow : 6"
• Condenser : 4"
• Full Load Amperage (7)
• 230/3/60 : 444
• 460/3/60 : 222
• 575/3/60 : 178
• Dimensions
• Height : 114"
• Width : 147"
• Depth : 147"
• Weight
• (9) Shipping : 6,505 lbs
• Operating : 20,705 lbs

• Specification Notes:
• 1. Since product innovation and improvement is our constant goal, all features and specifications are subject to change without notice or liability. Selection of certain optional features may change listed specifications.
• 2. Tons capacity at 12,000 BTU/ton per hour @ 50°F LWT @ 105°F condensing temperature. Capacities may be +/5% as reserved by the compressor manufacturer. Capacity multipliers are 50°F - 1.00 ; 40°F - .80 ; 30°F - .60 ; 20°F - .40. The minimum recommended operating temperature when no glycol is used is 48°F.
• 3. Flow rate (GPM) is based on 60°F city water source with a clean condenser.
• 4. Flow rate (GPM) is based on 85°F tower water source with a clean condenser.
• 5. Consult pump curve for exact pump performance.
• 6. Selection of optional pumps for higher flow rates will raise the minimum recommended operating temperature when no glycol is used.
• 7. Full load amps are higher than run load amps and must be used for sizing disconnects and supply wiring. Not for construction. Consult factory for power requirements of unit as configured and on selected options.
• 8. Consult factory for 50HZ operation.
• 9. Unit weight crated for shipment.

• Manual
• 
• Download
• 86 pages
• 5.5 MB

• Literature
• 
• Download
• 6 pages
• 1.8 MB

TI-90W

Image is typical. Actual unit appearance will vary according to specifications and options.