Air-Cooled Water Chiller | 20 Ton | Single Zone

Click here for an Instant Price Quote

For The OACS-20S-MG-1P ►

• Advantage OACS air-cooled central chillers use mechanical refrigeration to cool recirculated fluid that support industrial process cooling applications.
• 20°F to 70°F fluid temperature range.
• OACS air-cooled water chillers use ambient air to dissipate process heat and efficiently runs in air temperature between -20°F to 95°F.
• OACS systems are designed for outdoor installation in most types of climates. The air-cooled condenser, chiller zones, reservoir and pumping system are delivered as a complete package.

• Model: OACS-20S-MG-1P (1)
• Refrigerant Zones
• Quantity : 1
• Capacity
• (2) Tons : 18.7
• kW : 65.7
• Compressor
• Type : Scroll
• Refrigerant
• Type : R-410A
• Air-Cooled Condenser
• # of Fans : 2
• Evaporator
• Type : Brazed Plate
• Process Pump
• (3) HP : 3
• (4) GPM : 48
• PSI : 48
• Standby Pump
• Offered : Available
• Reservoir Capacity
• Capacity : 68 gal
• (5) Construction : PE
• Connection Sizes
• Type : 2"
• Size : NPT"
• Dimensions (6)
• Height : 87"
• Width : 54"
• Depth : 127"
• Controller
• Instrument Type : MG
• System Amperage (7)
• 460/3/60 : 52.0

• Specification Notes:
• 1. Since product innovation and improvement is our constant goal, all features and specifications are subject to change without notice or liability. Selection of certain optional features may change listed specifications.
• 2. Tons capacity at 12,000 BTU/ton per hour @ 50°F LWT @ 115°F condensing temperature. Capacities may be +/5% as reserved by the compressor manufacturer. Capacity multipliers are 50°F - 1.00 ; 40°F - .80 ; 30°F - .60 ; 20°F - .40. The minimum recommended operating temperature when no glycol is used is 48°F.
• 3. Consult pump curve for exact pump performance.
• 4. Selection of optional pumps for higher flow rates will raise the minimum recommended operating temperature when no glycol is used.
• 5. PE = polyethylene; SS = stainless steel; MS = epoxy coated mild steel.
• 6. Approximate dimensions. Not for construction purposes.
• 7. Full load amps are higher than run load amps and must be used for sizing disconnects and supply wiring. Not for construction. Consult factory for power requirements of unit as configured and on selected options.

• Literature
• 
• Download
• 6 pages
• 2.2 MB
• Includes Product Specifications

• Manual
• 
• Download
• 80 pages
• 3.5 MG

OACS-20S-MG-1P shown shown

Image is typical. Actual unit appearance will vary according to specifications and options.